Cap Rear Harness Buckle – For Costume Builds (Infinity-Inspired)

This is a 3D-printed rear harness buckle made for any Cap costume, modeled after the final-era uniform from the later missions. It’s a great way to add that realistic, battle-ready look to your setup.

Printed in silver PLA plastic with durability in mind, this buckle is designed to work with functional strap setups and hold its shape during wear.

📏 Measurements:

• 6" wide x 5.2" tall x 0.27" thick

• Fits 2" wide straps on top and 1.6" wide straps on bottom

You can paint it if you want, but honestly — it looks sharp right off the printer.

⚠️ This is a decorative costume piece and may break with enough force. Please handle with care during install and use.

📦 Ships FAST via USPS anywhere in the U.S. 🌍International customers - please see our eBay store for overseas shipping!

🔥 Heat Warning: PLA plastic softens at temperatures above 150°F. Clean using soap and lukewarm water only.

This is a 3D-printed item, and due to the nature of the process, minor blemishes, layer lines, or sharp edges may occur. These can typically be smoothed using a heat gun or hair dryer and light pressure.

We aim for a high standard of quality on every piece. If anything arrives less than perfect, reach out — we’ll make it right.